AKTERM Concrete – ultra-thin, thermal insulation, water-based intended for thermal insulation of concrete, bricks, and limestone surfaces. The coating can also be applied to putty and plaster. It is applied as a paint – acts as a thermal barrier! The liquid thermal insulation with only 1 mm of thickness protects against condensation and freezing.
AKTERM Concrete is easier to apply by spatula, but for hard-to-reach places – by brush.
Insulation of balconies, loggias, and basement
Thermal insulation of concrete, brick, foam block breathing walls
Walls, floor, and ceiling frost protection
Insulating interior walls
Insulation of window slopes
Used in the warm floor system instead of the traditional foil system
External protection of roofs, attics, attics from overheating.
When applying AKTERM Concrete of 1 mm thickness, the consumption will be 1 liter per 1 m2.
Recommended coating thickness range from 1.0 to 2.5 mm. To take into account that the thicker coating layer, the higher it’s thermal insulating properties.
Overconsumption is possible due to the high porosity of the surface.
Treat the surface with an acrylic primer before applying concrete.
The color of the coating after drying is white, you also can color it into light color.
At room temperature and normal humidity concrete with a thickness of 1 mm dries 24 hours.
After apply decorated plaste, hang or paint dry concrete with decorative water-based paint. Can be used as a finish covering.
When insulating layer get dry after 24 hours the surface can be exploited at temperature range from -60°С to +150°С.
Apply AKTERM Concrete with a thickness from 0,5 to 2 mm at ambient temperature from +10°С to +40°С and relative humidity not higher than 65%.
If the area of the processed surface is small, you can use a spatula or an ordinary brush.
Liquid thermal insulation is applied to large areas using a special airless sprayer (Graco Mark 5 or Mark 10).
It is necessary to use carbide nozzles to apply high heat paint, as ordinary nozzles get unusable quickly.
Packing and packaging: Plastic-pail 2, 5, 10, 20 L.
Conditions of Product transportation: at temperature from +5°С to +45°С;